Pilates equipment spring, maintenance and warranty guidance, by manufacturer

What each brand says about replacing springs and looking after its equipment, with the page or document that says it. Every link goes to the manufacturer's own site.

Links last checked .

Spring replacement guidelines

Most studio brands say two years, and the ones that count hours say 3,000. Where a brand gives more than one figure, both are here.

ManufacturerRecommendationSource
Align-PilatesReplace all springs after two years or 3,000 hours of use, whichever comes first; the warranty shortens this to one year in studios with six or more reformers. Inspect daily for deformation, kinks, gaps and corrosion, and rotate springs quarterly. The spring information page gives 2,000 hours, so take the lower figure if you run a busy studio.
Balanced BodyReplace all springs at least every two years, or every year for group fitness classes; roughly 3,000 hours of use. Inspect weekly or monthly for gaps, kinks and rust, and stop using a spring as soon as any shows.
BASI SystemsInspect springs weekly for gaps or kinks and replace any spring that shows one immediately. Replace all springs after at most two years of use. The warranty adds a 3,000-hour limit, whichever comes first.
Elina PilatesChange the springs every two years, and sooner on heavily used machines. Not changing them every two years may void the warranty.
GratzInspect springs weekly for distortion or unusual noise. Replace every 18 months with consistent use, or every 24 months with lighter use, and immediately if a spring looks distorted or sounds different.
Merrithew (STOTT PILATES)Replace all springs every 24 months and spring clips every 12 months, or sooner as needed. Inspect springs for wear and damage weekly. Not changing springs every two years may void the warranty.
Peak PilatesReplace each spring every two years, and immediately if the coils separate even slightly or show any other sign of fatigue.
Personal HourSprings are wearable parts with a finite lifespan. Inspect them regularly for wear, rust or damage and stop using any spring that appears damaged. No replacement interval is published.
Your ReformerReplace springs every few years depending on use, and sooner if they start to creak. Rotate springs evenly so they wear together, and leave one red spring attached when the reformer is idle.

Not published: Legacy Pilates Apparatus (Contact Legacy), NordicTrack (iFIT customer service, +1 833 680 4348), Technogym (Technogym technical support, +1 855 426 0421). We couldn't find a spring replacement interval on their sites; ask them directly.

Care and maintenance

A summary of each brand's published routine, then the pages that give it in full. Lubrication advice differs between brands, so follow your own manufacturer's.

Align-Pilates

Daily, check upholstery, runners, springs, ropes and shoulder rests. Weekly, check nuts and bolts, the foot bar, ropes and handles, wheels, eyelets and feet. Rotate springs every quarter, replace carriage wheels after a year of use and all springs after two. Don't apply lubricant to the rails, and never try to lubricate the wheel bearings, which are sealed for life. Align publishes a printable log sheet, a web checklist and a playlist of spring, wheel and rope replacement videos.

Sources

Balanced Body

Wipe down the tracks and clean the wheels weekly. Check snaps and bolts monthly. Inspect ropes, straps and springbar hooks quarterly, and replace ropes once the core shows through the cover or they flatten. Rotate same-weight springs each quarter to even out wear. Never spray silicone near the wheels, and don't lubricate Allegro 2 rails. Balanced Body also sells a printed equipment maintenance log with weekly and quarterly checklists.

Sources

BASI Systems

Inspect springs and spring hooks weekly, and tighten nuts, bolts and screws monthly, including the push-through bar and Cadillac swing. Replace ropes at any sign of wear. Wipe upholstery, carriage, foot bar and shoulder rests after each use with a damp cloth and mild soap, never alcohol, baby wipes or bleach, and never spray cleaner directly on the equipment. Brush the carriage tracks and run the wheels over a damp cloth periodically. Keep equipment out of direct sunlight and heat.

Sources

Elina Pilates

Keep the equipment clean and free of dust, especially the guides and wheels, and wipe it down with water and a microfibre cloth after each use. Elina recommends silicone oil spray to lubricate wheels, guides and metal parts, which differs from most other brands, so follow it on Elina equipment only. Spare parts for every model are available by email. Elina's FAQ mentions PDF manuals and assembly videos, but none are published on the site.

Sources

Gratz

Clean and lubricate the reformer wheels every three months, greasing only the interior bearing and never the wheel itself or the tracks (Gratz recommends Molykote 44 Medium; not for Triopine wheels). Inspect straps weekly and replace them about every 18 months. Clean upholstery with a 1:10 dish soap solution and avoid essential oils. Gratz's maintenance guide and YouTube playlist cover squeaks, footbars, chairs and clips, and Gratz keeps a directory of independent maintenance providers.

Sources

Legacy Pilates Apparatus

Legacy publishes cleaning guidance only: use non-chemical, non-alcohol cleaners such as liquid soft soap or organic surface cleaners. Assembly instructions are available for each apparatus, and replacement springs, straps and hardware are sold online. No inspection, lubrication or spring replacement guidance is published.

Sources

Merrithew (STOTT PILATES)

Daily, clean the rollers and wipe the rails with a soft damp cloth. Weekly, inspect the springs and sit on the carriage to listen for thumping or grinding from the rollers. Monthly, check rope wear and make sure every spring clip is fastened properly. Yearly, replace all spring clips. Every two years, replace all reformer springs, including vertical frame springs. Never use oil lubricants, which can damage the rollers. Merrithew publishes a printable schedule with a sign-off log, and the Spring Center sends replacement reminders if you register your serial number.

Sources

Peak Pilates

Visually inspect the machine daily and thoroughly inspect all hardware every two months. Replace ropes with fraying or tearing immediately. Wheel bearings are sealed and permanently lubricated, so there is nothing to grease; check the axles every two to three months. Wood needs only an occasional wipe with mild soap or furniture polish, and vinyl a daily wipe with a silicone-free cleaner. Each model's owner's manual carries a pre-use check.

Sources

Personal Hour

Keep the rails clean and free of dust, hair and small particles. Wipe the springs with a clean, dry cloth after each use. Check moving parts such as springs, pulleys and hinges for wear or squeaking. Avoid harsh cleaners and excessive lubricant. Short video guides cover lubricating springs, cleaning a wooden frame and adjusting wheels, footbar and stoppers, and the installation library has assembly instructions by model.

Sources

Your Reformer

Dust and wipe the rails weekly. Every few months, remove the carriage and tighten the carriage wheel nuts so it keeps tracking straight. Studios are asked to keep cleaning and servicing between preventative service visits. The knowledge base has how-to videos for spring and wheel changes; replacement springs and wheels are ordered by email rather than from a parts store.

Sources

Not published: NordicTrack (iFIT customer service, +1 833 680 4348), Technogym (Technogym technical support, +1 855 426 0421). We couldn't find care or maintenance guidance on their sites; ask them directly.

Warranty

Each brand's warranty page, with the headline terms. Several brands void the warranty if springs aren't replaced on their schedule, so the spring dates in your log matter here too.

  • Commercial reformers: 10 years on metal frames, 5 years on wooden frames and spring-bar mechanisms, 2 years on other parts, 1 year on ropes, straps, clips and wheels, springs 2 years or 3,000 hours, upholstery 90 days. Separate documents cover light commercial, home and chair models.

  • Limited lifetime on standard wood frames; 10 years on Allegro 2, Bravo and Contrology frames; Signature springs 2 years or 3,000 hours, 1 year in studios with five or more reformers; upholstery 90 days.

  • 10 years on main wooden frames; 2 years on steel and aluminium components, F2 systems and springs; 1 year on elastomer-coated parts such as foot bars, handles and wheels; 90 days on upholstery and fabric accessories. Not replacing springs every two years or 3,000 hours may void it.

  • EU terms: 10 years on wood and aluminium frames of commercial equipment, 5 years on Lignum and Nubium, 3 years on Domo, 2 years on all other parts, 90 days on upholstery. US terms differ, with a limited lifetime on rails and frame and 2 years on other components.

  • Lifetime on the structural frames of the Reformer, Cadillac, Studio Wall Unit and Guillotine Tower; 10 years on chair, barrel, mat and Pedi-Pole frames; 90 days on springs, parts and accessories. Loss of spring tension and surface rust aren't covered.

  • 10 years on aluminium, maple, walnut and teak frames and 3 years on solid panel frames, stated within the terms and conditions. Springs, wheels and other replaceable parts are excluded.

  • Lifetime on frames, welds, aluminium rails and footbar mechanisms of professional and at-home reformers, Cadillacs, chairs and barrels; 2 years on other components; 1 year on rollers, ropes, straps and spring clips; 90 days on upholstery.

  • 5 years on the frame and 12 months on components, parts and labour for the Ultra 1 reformers, as stated in NordicTrack's reformer buying guide. The full terms live on iFIT's legal page without durations.

  • Studio Wood Line: 10 years on the frame, 1 year on springs and other mechanical parts, 90 days on upholstery and ropes. Metal Peak PilateSystem: 5 years frame, 2 years components. MVe, fit and casa lines: 2 years structural, 1 year other parts.

  • 30 days on mechanical faults, 6 months on carriage wheels, rails and footbar parts, 1 year on parts, and 2 to 10 years on the frame depending on material. No spring or upholstery term is stated, and lack of recommended maintenance may void it.

  • 2 years from delivery on new equipment, excluding parts subject to wear, within the general sales conditions. The optional Technogym Care Plus plan extends it by two years. No spring or upholstery term is stated.

  • Frames, rails, gear bar and foot bar 5 years; springs, straps and ropes 2 years; upholstery and other components 1 year. A separate commercial warranty covers the Studio, Studio X and Envy.

Always follow your equipment manufacturer's instructions. This page doesn't replace them, and if the two differ, the manufacturer's guidance comes first.

Keep every inspection on record.

Hooke's Log is free for up to 5 pieces of equipment. Log checks, flag issues and keep every spring's replacement history in one place.

Start your free log